Skip to content

ROS package for reading continuous data output of the SICK S300 Professional laser scanner. Supports both the old (v.1.02) and the new (v.1.03) protocol

License

Notifications You must be signed in to change notification settings

grupo-avispa/sicks300

 
 

Repository files navigation

sicks300

ROS package for reading continuous data output of the SICK S300 Professional laser scanner via RS-422. Note that it supports both the old (v.1.02) and the new (v.1.03) protocol.

Please note that this is an extension of the original "fuerte" driver that was developed by the Autonomous Intelligent Systems Department at Bonn University.

Getting started

Make sure that all dependencies are satisfied:

$ rosmake sicks300 sicks300

Run the node:

$ rosrun sicks300 sick300_driver

Messages

Published Topics

  • /laserscan (sensor_msgs/LaserScan)

    Scan data

Parameters

  • ~frame (String, default: "base_laser_link")

    Laser frame

  • ~send_transform (int, default: 1)

    Send Transform from base_link to base_laser_link.

  • ~tf_x (double, default: 0.115)

    Transformation along x-axis

  • ~tf_y (double, default: 0.0)

    Transformation along y-axis

  • ~tf_z (double, default: 0.21)

    Transformation along z-axis

  • ~field_of_view (int, default: 270)

    The field of view to publish. The maximum view angle is 270 degrees, setting this to a value lower than 270 will remove the left and right sides of the field of view.

  • ~devicename (String, default: "/dev/sick300")

    Port connected to laser.

  • ~baudrate (int, default: 500000)

    Sets the baud rate

About

ROS package for reading continuous data output of the SICK S300 Professional laser scanner. Supports both the old (v.1.02) and the new (v.1.03) protocol

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • C++ 91.2%
  • CMake 8.8%