Skip to content

Latest commit

 

History

History
 
 

Folders and files

NameName
Last commit message
Last commit date

parent directory

..
 
 
 
 
 
 
 
 

Access Point Plugin (ap)

The ap collector visualizes data related to access points.

Example netdata charts

image

How it works

It does the following:

  1. Runs iw dev searching for interfaces that have type AP.

    From the same output it collects the SSIDs each AP supports by looking for lines ssid NAME.

    Example:

# iw dev
phy#0
        Interface wlan0
                ifindex 3
                wdev 0x1
                addr 7c:dd:90:77:34:2a
                ssid TSAOUSIS
                type AP
                channel 7 (2442 MHz), width: 20 MHz, center1: 2442 MHz
  1. For each interface found, it runs iw INTERFACE station dump.

    From the output is collects:

    • rx/tx bytes
    • rx/tx packets
    • tx retries
    • tx failed
    • signal strength
    • rx/tx bitrate
    • expected throughput

    Example:

# iw wlan0 station dump
Station 40:b8:37:5a:ed:5e (on wlan0)
        inactive time:  910 ms
        rx bytes:       15588897
        rx packets:     127772
        tx bytes:       52257763
        tx packets:     95802
        tx retries:     2162
        tx failed:      28
        signal:         -43 dBm
        signal avg:     -43 dBm
        tx bitrate:     65.0 MBit/s MCS 7
        rx bitrate:     1.0 MBit/s
        expected throughput:    32.125Mbps
        authorized:     yes
        authenticated:  yes
        preamble:       long
        WMM/WME:        yes
        MFP:            no
        TDLS peer:      no
  1. For each interface found, it creates 6 charts:

    • Number of Connected clients
    • Bandwidth for all clients
    • Packets for all clients
    • Transmit Issues for all clients
    • Average Signal among all clients
    • Average Bitrate (including average expected throughput) among all clients

Configuration

You can only set ap_update_every=NUMBER to /etc/netdata/charts.d/ap.conf, to give the data collection frequency. To edit this file on your system run /etc/netdata/edit-config charts.d/ap.conf.

Auto-detection

The plugin is able to auto-detect if you are running access points on your linux box.

analytics