The MCUmeter started as a gift for a "secret santa" round at my favourite electronics club, the Boldport Club. It was something I always wanted to do because it's useful, simple to build and can offers a nice learning experience for people who want to do microcontroller based hardware themselves.
In a nutshell it’s a high performance voltage/current/power monitor which will render it’s voltags/current/power readings supplied by a Texas Instruments INA260 via a STM32F042 microcontroller onto a small OLED display.
It consists of two main ingredients:
- Custom made hardware, which is what this repository is all about
- Software which is written in Rust and can be found here or directly on crates.io
The hardware design was done in KiCad and this repository contains both the KiCad 5 design files as well as the Gerber files which can be sent directly to a fab house to build the project, like the one I used for the prototypes. If you'd like you can order them directly from Aisler using this link.
This is what the boards look like: 
and 
The INA260 allows sensing voltages (DC and positive values only!) up to 36V and high-side as well as low-side currenty (polarity not relevant). It can also do the power calculations, although at reduced precision.
The connections (from left to right) are
- V_IN: Positive voltage to be measured. Important! This power meter does not like negative voltages so watch the polarity!
- I_IN+/I_IN-: High-side (i.e. connected between the power supply and DUT) or Low-side (i.e. connected between ground and the DUT) current measuring. Polarity irrelevant.
- GND: Ground of voltage measurement, common with the rest of the circuit
It also provides a 4-pin header to connect a SSD1306 OLED display with I2C interface using the following pinout:
- VCC
- Ground
- SCL
- SDA
The connectors can be either soldered onto the board or screwed on, good results have been achieved with e.g. MC/Stäubli XUB-G
Absolutely, everything is licensed under the BSD license so please go ahead and use it however you'd like.